Animal Glue: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 4: | Line 4: | ||
| URL-Name= Animal_Glue | | URL-Name= Animal_Glue | ||
<section begin=Cost /> | |||
| Cost = 5 sp | | Cost = 5 sp | ||
<section end=Cost /> | |||
| Weight = <section begin=Weight />0.5<section end=Weight /> | | Weight = <section begin=Weight />0.5<section end=Weight /> | ||
Revision as of 02:36, 12 January 2018
- Cost: 5 sp
- Weight: 0.5 lbs.
This simple glue is created by extensively boiling animal skin, bones, hooves, horn, and tendons until they turn into a ocher syrup that cools when it hardens. Before you use animal glue, you must heat it until it liquefies. You normally apply it with a brush and hold the pieces together for a minute, at which point it is cooled and hardened. The glue is sufficient to coat 1 square foot of surface, or (because of waste and spills) up to 40 smaller applications of approximately 2 square inches each. Pulling apart a large glued surface (at least 1 square foot) requires a DC 19 Might check. Pulling apart a small glued surface (anything less than 1 square foot) requires a DC 15 Might check. Animal glue slowly dissolves in water, reducing the DC needed to break it by 1 per 10 minutes. It softens if heated, even with steam, reducing the Strength DC needed to break it by 1 per minute.
- Crafting: Profession (Tanner) (DC 15)